mofusand Chip pop (Yurunyan)

Compatible with iPhone's MagSafe, it can be attached to the back of the iPhone with a magnet, supporting the iPhone's holding, and can also be used as a stand.
Additionally, you can use the MagSafe charger while this product is attached.

*MagSafe is a feature equipped on iPhone 12 and later models. SE series are excluded.

Size (approx.): 57×H3mm (in use: 24mm)
Weight (approx.): 16g
Material: PP, PC, aluminum, magnet
Manufactured in: China

*If using a MagSafe-compatible iPhone or case, this product can be attached directly.
*For non-MagSafe iPhones or cases, and Android devices, clean any dirt or oil from the attachment area, peel off the adhesive seal on the outer frame of the back of the product, and stick it on. (Do not peel off the central black part on the back)
Please note that the adhesive seal is strong and cannot be repositioned.
*When using this product with non-MagSafe iPhones (8-11, SE series), ensure the center of the device and the product align. Misalignment may prevent charging or cause the product to heat up when using a MagSafe charger.
*When attaching this product to an Android device and performing wireless charging, ensure the center of the wireless charging coil inside the device's back matches the product's center.
*When removing this product, gently peel it off from the edge of the adhesive surface. Residue may remain on the seal.
*If using this product with a thick case, wireless charging speed may be extremely slow, or charging may not occur if the output of the wireless charger is low. In such cases, please remove the product or case before performing wireless charging.
*Wireless charging with this product attached may cause the charger to become hotter than usual, but this is not a malfunction.