mofusand Chip pop (Shark Meow)

It can be magnetically attached to the back of the iPhone, supporting iPhone's MagSafe, and can be used to support the iPhone or as a stand.
Additionally, you can use a MagSafe charger while this product is attached.

*MagSafe is a feature equipped on iPhone 12 and later. SE series are excluded.

Size (approx.): Diameter 57×H3mm (in use: 24mm)
Weight (approx.): 16g
Material: PP, PC, aluminum, magnet
Manufactured in: China

*For iPhones or cases that support MagSafe, you can directly attach this product.
*For iPhones or cases that do not support MagSafe, or Android devices, clean the attachment area of dirt and oil, peel off the protective film on the back outer frame of the product, and attach it with the adhesive seal. (Do not peel off the black circle part in the center of the back) The adhesive seal is strong and cannot be reattached, so please be careful.
*When using this product with non-MagSafe iPhones (8~11, SE series), attach it so that the center of the device and the center of the product align. If the center position is off, there might be cases where charging is not possible or the product heats up when using a MagSafe charger.
*When attaching this product to an Android device and performing wireless charging, attach it so that the center of the wireless charging coil inside the device and the center of the product align.
*When removing this product, peel it off slowly from the edge of the adhesive surface. There might be cases where adhesive residue is left behind.
*When using this product with a thick case, if the output of the wireless charger is low, the charging speed may be extremely slow or charging may not occur. In such cases, please remove the product or the case before performing wireless charging.
*Wireless charging with this product attached may cause the charger to generate more heat than usual, but this is not a malfunction.