mofusand Chip pop (Rabbit Meow)

You can attach it to the back of the iPhone with a magnet compatible with iPhone's MagSafe, supporting the iPhone's hold, and use it as a stand.
Additionally, you can use the MagSafe charger while it is attached.

*MagSafe is a feature equipped on iPhone 12 and later models. The SE series is excluded.

Size (approx.): Direct 57×H3mm (when in use: 24mm)
Weight (approx.): 16g
Material: PP, PC, aluminum, magnet
Manufactured in: China

*When using an iPhone or case compatible with MagSafe, you can attach this product directly.
*For non-MagSafe compatible iPhones or cases, or Android devices, clean any dirt or oil from the attachment position, peel off the adhesive sheet on the back outer frame of the product and stick it. (Do not peel off the black circle part in the center of the back) Note that the adhesive sheet is strong and cannot be repositioned.
*For non-MagSafe compatible iPhones (8~11, SE series), align the center of the device with the center of the product when attaching. Misalignment may prevent charging or cause the product to overheat when using a MagSafe charger.
*When attaching this product to an Android device and performing wireless charging, align the center of the device's internal wireless charging coil with the center of the product.
*When removing this product, slowly peel it off from the edge of the adhesive surface. Residue may remain on the seal at this time.
*When using this product with a thick case, if the output of the wireless charger is low, charging speed may be extremely slow or charging may not occur. In such cases, remove this product or the case before performing wireless charging.
*Wireless charging with this product attached may cause the charger to heat up more than usual, but this is not a malfunction.